Home » Categories » Equipment

What do I do if my remote control will not change the channel?

In order to resolve problems with your remote control, please try the following: ·         Make sure the power light on your receiver is lit. ·        Check to see if the remote control light is flashing repeatedly. If so, please replace your batteries with two new alkaline batteries. ·         Go up to the receiver and try changing the channels without using the remote control. ·         Refer to the remote control setup instructions, and make sure you have the correct codes programmed for your equipment. ·         Make sure nothing is blocking the front of the receiver (e.g., furniture). ·         Make sure you are operating the remote control within 20 feet of the receiver.
1 (36)
Article Rating (36 Votes)
You've Already Voted.
  • Icon PDFExport to PDF
Attachments Attachments
There are no attachments for this article.
Related Articles
Will I need to purchase any special equipment to use Blue Ridge DVR?
Viewed 2554 times since Fri, Jan 18, 2008
My On Demand service is not working, how do I fix it?
Viewed 26126 times since Fri, Jan 4, 2008
Can I get digital services on all TVs in my home?
Viewed 7605 times since Fri, Jan 18, 2008
What is a Digital Receiver?
Viewed 3233 times since Mon, Dec 10, 2007
Does the DVR allow me to watch and record high-definition programming?
Viewed 1997 times since Mon, Dec 10, 2007
Only getting channels 3 & 4 on TV.
Viewed 2178 times since Wed, Aug 22, 2007
What is the difference between coaxial cable and fiber- optic cable?
Viewed 5696 times since Mon, Dec 10, 2007
There isn't any audio when using HDMI with a Digital box?
Viewed 3243 times since Fri, Jan 4, 2008
Can I purchase a 24hr back up battery for the phone modem?
Viewed 2809 times since Wed, Aug 22, 2007
Can I reset the time on the Digital Receiver?
Viewed 1848 times since Mon, Dec 10, 2007